nTrust Non Programmable Thermostat (UTN4)


The nTrust Non Programmable Thermostat with built-in GFCI provides optimal comfort in controlling electrical underfloor heating - all with a stylish design.
This support page provides publications, manuals, videos, support articles, and common support questions for the nTrust Non Programmable Thermostat product line.


Main Products (3)

question-mark
Common Support Questions (7)

publication
Publications and Manuals (10)

Videos (4)

Articles (5)

Create a new Support Request

Common Support Questions


The breaker and wire sizes are selected based on the total amperage of the WarmlyYours heating system connected to a single thermostat. This information is on the WarmlyYours heating system's installation plan, electrical plan, or UL label. Based on guidelines from the National Electrical Code: loads up to 16 Amps may utilize 12 gauge wire with a 20-Amp breaker, and loads up to 12 Amps - 14 gauge wire with a 15-Amp breaker. Local code and/or other factors may change these guidelines.

Need more help? View support options

Pressing and holding (2-3 sec) physical power/reset button will turn the unit completely OFF. Same process turns the unit back on.

(nHance and nJoin units will have the button on the front faceplate, nSpire Touch WiFi, nSpire Touch and nTrust will have the button on the right side of the faceplate.)

Need more help? View support options

Solution:

The ground wire in the floor mat must be connected directly to the ground wire of the supply or to the house ground wire.


Need more help? View support options

Yes, the floor sensor wire can be extended up to 300 feet with 18 AWG wire.

Need more help? View support options

All thermostats are mandated at 42" height for handicap accessibility, most private residences are mounted at 52-60".

Please see this video on how to install a WarmlyYours nSpiration Series thermostat: https://www.warmlyyours.com/video-media/wire-nspiration-thermostat-to-electric-floor-heating-roll

Need more help? View support options

Solution:

Yes the adaptive function is reset during a factory reset.


Need more help? View support options

Cause:

The connection is incorrect

Solution:

Check the connections between the two units. If the USG is connected incorrectly to the thermostat, the USG won't switch off.


Need more help? View support options


Publications and Manuals



Videos



Articles




Speak to a radiant heating expert


Can’t find what you’re looking for? Create a Support Request