How to wire a WarmlyYours SCP-120 Snow Melting Controller
Unlock the Power of Your SCP-120 Controller: Step-by-Step Guide to Sensor Connections
Wrestling with a poorly heated driveway or walkway in the winter can be frustrating and dangerous. Our video guide demystifies the process of correctly wiring the SCP-120 snow melting controller, ensuring efficient operation and a reliably heated surface.
- An introduction to the SCP-120 controller, aerial sensor, and in-slab sensor components.
- Step-by-step guide to correctly open the controller and expose the terminal strip.
- Detailed instructions on connecting the wires to the appropriate terminals for optimal operation.
- Expert tips to prevent short circuits and maintain a tidy, efficient wiring setup.
- Useful information about the role of the sensors in maintaining the right temperature and detecting snowfall.
- Guidance on using a jeweler's screwdriver for securing the screw-down type connections.
Whether you're a homeowner looking to optimize your snow melting system, or a professional installer wanting to perfect your technique, this video is an invaluable resource. Learn to make the most of your premium controls and create a safe, warm surface regardless of the weather.
Hello, I'm Scott from WarmlyYours, and today we're going to discuss the low voltage connections between our SCP-120 controller and the aerial sensor and slab sensor. This guide will help you understand where to make these connections to ensure your system operates correctly.
In this setup, we have our controller, along with the in-slab sensor, which continuously monitors the temperature of the slab, and the aerial sensor, which detects the air temperature and snowfall. To make the necessary connections in the controller, you'll need to open the front cover. You'll notice that we have already removed some screws, but there are additional screws that will need to be taken out. Additionally, you will need to pop the plastic rivet located on the front to fully remove the cover.
Once the front cover is off, you'll see where the connections will be made. We have removed the metal bracket from the box to make it easier for you to see the connection points. The connections we will focus on are located along the terminal strip, which is numbered for your convenience. Specifically, we will be connecting to screws number 1, 2, and 3, as well as screws number 10 and 11, which correspond to the aerial snow sensor and the in-slab temperature sensor.
Looking at the wiring terminal strip, terminals 1, 2, and 3 must be connected in a specific order: white wire in terminal 1, black wire in terminal 2, and red wire in terminal 3. For terminals 10 and 11, the color of the wires does not matter, so you can use black or red interchangeably. The key is to ensure a solid connection between terminals 10 and 11.
When making these connections, it's important to minimize the amount of excess wire hanging out to prevent any chance of short circuits if the wires happen to cross inside the controller. The wiring space can be tight, so aim to keep the insulation close to the terminal connections. These connections are simple screw-down types, and a small screwdriver, such as a jeweler's screwdriver, will suffice for this task.
That's how easy it is to make your low voltage sensor connections with the SCP-120. If you have any further questions, feel free to contact us at www.warmlyyours.com.