Tech Tips: Wiring Environ to a Thermostat
How To Wire Environ Electric Heat Systems to a Thermostat
When you're installing a heated floor system from WarmlyYours, setting up a thermostat ensures that you'll be able to use the floor as efficiently as possible. Attaching the Environ II system to the back of a thermostat is not a complicated job, but it’s something you'll want to do carefully to guarantee it works properly and won't cause any problems. In this helpful and informative video, you’ll learn about how to wire the Environ II system to a thermostat.
At WarmlyYours, you'll have the choice of four different thermostat controls, ranging from a simple programmable timer to a thermostat with floor temperature controls. Get the most out of your radiant floor system with WarmlyYours Environ II systems.
If you look at the back of
the thermostat, you can see that there are four wires. The bottom wire here and
the top wire are the wires that are getting power from the circuit breaker box.
You can see that's called out on the drawing on the back of the thermostat. If
you look here on the back of the thermostat you see the words load. That's
signifying these two middle wires. These two middle wires are the wires that
are going to be hooking up to the wires coming from the Environ II system. The easy
thing to do is if you have a 240 Environ system, these wires are going to be
just as shown. They're going to be red and black. If this were 120 volt, this
would be yellow, black and green.
You always attach the black to the black.
That's the easiest thing to do. With this case, since it's 240, we're going to
attach the red to red. However if this were 120 mat, we would be attaching the
yellow to the red. Anyway, it's very simple connection. All you need to do is
twist the wires together. We're going to twist the black wires together as so
and use a twist cap. Next thing is to pair up the red wires. Now we have the
two wires attached. This green wire will go to the ground that's located in the
box that the thermostat mounts to.
That's
how you attach your Environ II system to the back of a thermostat.
