IP-XC500-WIM Frequently Asked Questions
Frequently Asked Questions
Showing all 8 questions
Yes, if it’s mounted away from the tub and shower, where nobody in the bath or shower can touch it. Plug it into a GFCI-protected outlet, or have a licensed electrician hardwire it to local code. Hang towels on a towel bar, never on the panel.
No, infrared heating panel heaters are designed and rated to be installed outside of a shower or bath enclosure.
Panels are not designed for painting/drawing over, such use will void the warranty of the product.
Infrared heating panels are designed for supplemental heating, not as a primary heat source. They work best to boost warmth in specific rooms or offset cold spots, but most homes require a central heating system for whole-home comfort.Why panels are supplemental:
- Coverage area: Each panel heats 50–150 sq.ft. (one room or zone)
- Wattage limits: 300–800W per panel (not enough for whole-home heating)
- Installation: Requires multiple panels for multiple rooms (costly for whole-home coverage)
Best use cases for supplemental heating:
- Cold rooms: Basements, sunrooms, garages, workshops
- Spot heating: Home offices, bathrooms, bedrooms
- Zone heating: Heat only occupied rooms (save energy)
- Seasonal use: Three-season rooms, vacation homes
- Supplement existing heat: Boost warmth without cranking up thermostat
When panels CAN be primary heat:
- Tiny homes: 200–400 sq.ft. spaces (1–2 panels sufficient)
- Well-insulated spaces: Modern, energy-efficient construction
- Mild climates: Regions with minimal heating needs
- Single-room dwellings: Studio apartments, ADUs
Sizing guidance:
Use our Heat Loss Calculator to determine if infrared heating panels can meet your heating needs or if they’re best used as supplemental heat.
No — painting the face of a panel changes its surface emissivity and can reduce heat output, and it may void the warranty. Choose a factory finish instead: WarmlyYours infrared heating panels come in glass, mirror and white finishes (including a mirror option that doubles as a full-length mirror) designed to radiate heat efficiently while complementing your décor.
Panels installed in a bathroom should be installed in compliance with your local electrical code, or at least 2 feet away from the perimeter of a wet area (shower or bath enclosure).
It depends on wattage, run time and your electricity rate. A 300 W panel uses 0.3 kWh for each hour it runs, and an 800 W panel uses 0.8 kWh; multiply by your rate per kWh. A thermostat or timer keeps the cost down by running the panel only when you need it.
Allow about 7 watts per square foot in a room with average insulation, so a 10 × 10 ft room (100 sq ft) needs about 700 W. Each Ember product page lists the area its panel covers, such as 86 sq ft for 600 W. High ceilings, large windows or poor insulation need more wattage, and a large room heats more evenly with two panels. For an exact size, ask us for a free heat loss calculation.