24″ Brushed Towel Holder Bar for Ember Radiant Heating Panels (Excludes IP-EM-FLX-WHT-0300-CW)

Yes.

Verify 120V power at the connection of the panel to the circuit at the junction box in the wall (for hardwired connections), or at the outlet (for plug-in connections). Each Ember heater has a built-in safety switch that turns off the heating element automatically if it overheats. By unplugging or disconnecting the unit and waiting for about 10 to 15 minutes, the safety switch will reset automatically and the unit will be operational again.

If you experience additional issues, please give us a call at 1-800-875-5285.

No, the back of the panel has only two pre-drilled locations. One at the upper half of the unit and one at the lower half.

The bar simply being screwed-in to the pre-drilled holes on the back of the panel.

Ember Infrared Heating Panel is 24 inches in width and either 35 or 47 inches in length and the average bath towel is 20 -24 inches wide by 40 to 50 inches long. With these dimensions, one towel draped in half over the bar performs best. Two hand towels draped in half would work well too, as hand towels tend to be about 12-15 inches in width.

One towel draped in half, or two hand towels draped in half.

No, the bar is not heated.