Self-reg Heat cable, 120V 10 watts per ft, jacketed UL
This support page provides publications, manuals, specifications, videos, support articles, and common support questions
Support Questions
Showing all 6 questions
Unfortunately there's no set answer for this because it depends on many factors such as the diameter of the pipes, the installation density of the heating cables, the outdoor temperature, the installation of thermal insulation sleeves, etc.
There are too many variables to provide an accurate answer. Even though this product is designed to keep pipes from freezing, it is not designed to thaw pipes. If your pipe has frozen with the heat tape installed and energized, please check the placement of the built-in thermostat and verify that the insulation has been properly installed and waterproofed.
Documents
Installation
- Constant Wattage Pipe Freeze Protection System Installation Manual (English)
- SR-PLUG-KIT Plug-in Conversion Kit with Ground Fault Equipment Protection (GFEP) Installation Manual (English)
- Self-Regulating Pipe Freeze Protection PT-DUAL Installation Sheet A (English)
Sell Sheets
- PRO-Tect Constant Wattage Heating Cable for Pipes Sell Sheet USA (English)
- Self-Regulating Pipe Freeze Protection Dual-Zone Control PT-DUAL Sell Sheet (English)
- Self-Regulating Pipe Freeze Protection Single-Zone Control PT-SINGLE Sell Sheet (English)
Operation Manuals
- Self-Regulating Pipe Freeze Protection PT-DUAL Manual (English)
- Self-Regulating Pipe Freeze Protection PT-SINGLE Manual (English)
Project Planners
Specifications
Electrical
| Amps | 1 A |
| Voltage | 120 V |
| Watts | 1 W |
Product Dimensions
| Length | 1″ |
| Weight | 0.1 lbs |
| Width | 1″ |
Identifiers
| SKU | CLT10-JT |
Videos
Similar Items
Do you need support or specifications for a specific model? Identify your model below.