Roof and Gutter Deicing Accessories
A complete roof and gutter deicing installation needs four things besides the heating cable: a power connection kit to energize the run and seal its end, aluminum clips to hold the cable to the roof, double-sided gutter pads to bond those clips down, and a control to switch the system on. WarmlyYours stocks all of them, so one order covers the whole job.
Mounting hardware does most of the work. Aluminum 3-prong clips attach the cable to asphalt shingle and metal roofs, and 3" x 2" VHB gutter pads bond those clips to the roof or gutter — with ET-94-PRIMER where rubber, EPDM, or another slick surface resists adhesion. Switching is handled separately by roof deicing thermostats and controls. The automatic models pair with temperature and moisture sensors so the cable runs only when ice is actually forming.
Keep a repair kit on hand as well. Ours includes pre-cut heat shrink tubing along with connectors and high-conductive grounding tape — enough to fix a nick or cut in the wiring during installation instead of starting the run over. Ordering your accessories with the system is the simplest part of preparing your radiant heating system for winter.
Essential Roof Deicing Accessories Checklist
Everything a self-regulating deicing run needs beyond the cable itself.
Roof Deicing Power Connection Kits
Ground-fault-protected plug-in and hardwired power kits for ET-SR cables. One kit is required per cable run, and each includes an ET-END-KIT end seal.
Gutter Pads, Clips & Adhesives
Gutter heating cable clips, double-sided gutter pads and primer for mounting self-regulating cable to roofs and gutters.
These double‑sided tape pads are used to affix aluminum clips to roof and gutters.
-
3" x 2" pads
-
25 pads per package
-
ET‑94‑PRIMER may be needed for sufficient adhesion on some surfaces (refer to primer description for details)
-
Install when temperature is above 50° F for best results
Required for use on rubber, EPDM, and some other surfaces to promote adhesion of VHB tape pads. 1‑quart container.
Ideal for attaching self‑regulating deicing cable to typical roof and gutter surfaces, such as metal and asphalt shingle.
-
25 clips per package
-
Use ET‑VHB‑PAD‑P25 double‑sided tape pads to affix clips to roof
-
Typical installation recommendations: Gutters — 1 clip per 10 feet of gutter, plus 2 for each downspout; Roofs — 5 clips per triangle in zigzag installation pattern
Frequently Asked Questions
Showing all 5 questions
WarmlyYours self-regulating cable is suitable for use on standard asphalt or wood shingles, angled cedar, tile or terra cotta, slate, flat membrane-type (rubber or EPDM) roofing, and metal roofing. For attaching, the same clips are used for both slate and cedar roofing. Always check local codes for approved methods of heating roofs and gutters.
WarmlyYours does not recommend installing de-icing systems on ribbed metal roofs. Ribbed and corrugated panel designs typically lack the flat surface area required to properly adhere standard mounting pads and clips. Without a flush mounting surface, heating cables cannot be safely secured to the roof structure. Always evaluate your roof profile and material compatibility before purchasing your de-icing cable.