Single cable 3 prong copper clip-retrofit - 16″ Strap

WarmlyYours self-regulating roof and gutter de-icing cable can be used on rubber or EPDM (Ethylene Propylene Diene terpolyMer) roofs.

The primer that WarmlyYours sells is specifically for adhering clips to EPDM or rubber roofing.

A 2 pole single-phase 240V circuit works by continuously monitoring the current flowing through both hot wires of the circuit. If it detects even a slight imbalance between the current on each hot wire (indicating a ground fault), it will quickly trip, cutting off power to the circuit. Essentially, it compares each leg of the 240V circuit and trips if they are not precisely equal.

WarmlyYours offers a conversion kit (SR-PLUG-KIT) to enable a plug-in requirement. This kit includes ground fault equipment protection (GFEP). The receptacle must be 120V, grounded, and approved for wet locations if located outside. The self regulating cable must not exceed 140‘ in length.

No.  Aluminum 3-prong clips can cause rapid galvanic corrosion if they come in direct contact with copper.  WarmlyYours recommends using our Self-Regulating roof & gutter cable fastened with 3-prong Copper clips (ET-CL-CU-P25) and double-sided adhesive pads (ET-VHB-PAD-P25) for this application.