Remote Manual Override Device (RCO) RCO


Part Number: RCO
This support page provides publications, manuals, specifications, videos, support articles, and common support questions


question-mark
Common Support Questions (5)

publication
Publications and Manuals (3)

specifications
Specifications (8)

Videos (6)

Articles (4)

Related Items (2)

Create a new Support Request

Shop Now

Common Support Questions


Never cut the heating cable. A heating cable will not work if it has been cut. If the heating cable is too long, call WarmlyYours to consult with a technician who will guide you in utilizing the additional length of cable.

Need more help? View support options

When installing outdoor WarmlyYours snow melting cables for your driveway, patio, walkway, terrace, stairs, ramp, etc. - NEVER cross, overlap, or allow the heating cables to touch each other. Doing so will quickly cause a circuit failure due to excessive heat build up. Always follow the installation instructions and/or design layout plan to ensure the cable is installed with the correct spacing required for proper operation.

Solution:



Need more help? View support options

This National Electric Code (NEC) required protection for fixed outdoor deicing and snow-melting equipment may be accomplished by using circuit breakers equipped with ground-fault equipment protection (GFEP) of 30 mA. It is important to understand that this required equipment protection is not the same as a 5 mA GFCI used for personal protection.

Solution:



Need more help? View support options

If a cable is damaged during installation, recheck the system for continuity and confirm the integrity of the insulation with a megohmmeter, or "megger" tester, referring to the installation and testing instructions. If the cable fails any of these tests, take the following actions: clear a 3 foot square working area around the damaged section of cable, and record the cable part number from the UL tag and the location where you purchased the product. Call WarmlyYours with the above information. WarmlyYours will provide further assistance and supply a splice kit suitable for repairing the particular cable.

Need more help? View support options

In addition to showing the status of the snow/ice melting system and controlling the hold-on time, the RCO will turn on/off the heat for these controllers.

Note:  When the Heater Cycle switch is momentarily depressed, it will start a manual Heater Cycle for the Cycle Time setting.  Momentarily depressed while heaters are being operated by a Hold-On Timer or during manual Heater Cycle will end the Heater Cycle. Heater operation during snow conditions cannot be canceled in this manner.

Need more help? View support options


Publications and Manuals



Specifications


Product Dimensions

Length 5.25″
Width 7.25″

Electrical

Maximum Distance from Controller 500′
Voltage 24 V

Logistics

Package Contents RCU-3 Remote Control Unit (Qty 1), Wallplate Screws (Qty 2), 25′ Unshielded 22 Gauge 2-wire Jacketed Cable, Installation Manual

Identifiers

SKU RCO
UPC (GTIN-12) 881308021122

Warranty / Certifications

Warranty 2 years

Videos



Articles




Speak to a radiant heating expert


Can’t find what you’re looking for? Create a Support Request